Wall Mounted Cistern Leaking

The leak is on the left edge of the toilet base looking straight on rather than the middle.

Wall mounted cistern leaking.

Water leaking at the top of the toilet can run or drip down and pool near the. The leak is where the flush pipe from the cistern enters the pan. I ve tried refitting about 4 times still it leaks. Wall mounted toilet leak repair 1.

And the bowl itself can be adjusted to sit anywhere from 15 to 19 inches off the ground. Wall hung toilet leaks are a tricky problem to fix given that most of the hardware is ac. Pull off the rectangular flush actuator panel cover located on the wall above the toilet bowl to reach the flush valve of the toilet. In this video we talk about how to repair a wall hung toilet leak.

If water is detected tighten the. The flush valve consists of a horizontal bar attached to a plastic rod or spindle that is inserted into the flush actuator. How to troubleshoot a leaky wall hung toilet 1. 2 problems that can occur with a wall hung toilet include it feeling loose or jiggling when you sit on the toilet and the toilet leaking at the wall when you flush it.

Common problems with wall hung toilets. Wall mounted toilets can save as much as 10 inches by moving the tank into the wall. Sometimes water will leak if the bowl is not firmly. The culprit for my leaking toilet was the rubber seal underneath and there s a big thread plastic nut that goes up underneath the system that holds that on and gives the cistern a water tight seal.

It must have leaked for a bit and then stopped. The problem with a toilet that rocks or feels that it is coming loose is that it has not been properly seated against the wall. There is a supplied rubber bung that is supposed to seal to the ceramic socket. You can see dried limescale where it leaked on the other side in the past.

Looking at the wall and floor it has been leaking on the other side in the past. Feel the shut off valve packing nut located behind the valve handle for moisture. Lift the lid at the top of the tank. Step 2 inspect the plastic rod or spindle of the flush valve.

Tighten the bolts that secure the toilet bowl to the wall.